1. Glued the horizontal and vertical tails to the fuselage.
2. Centred the elevator and rudder control servos.
3. Connected the servos to the elevator and rudder control arms, using thread.
4. Installed the propeller
5. Connected the motor wiring, servos and solar panel wiring to the receiver
6. Adjusted the wheels to give some toe-in and camber, to ensure good ground tracking
7. Tested all controls and engine-propeller connections using a lamp as a light. Made sure propeller turned clockwise from the rear.
8.
Glued a ¼ inch balsa strip to the wing undersurface leading edge, to provide
some wing incidence for lift. Attached the wing to the fuselage with rubber
bands, at the leading edge location calculated above.
<<Back