Large Rubber-made Container 28” long, 15” wide and 16” deep (1) 1”x1” boards 11” long (2) 1”x1” boards 39” long (2) 1”x1” boards 36 1/2" long (2) 1 1/2"x1 1/2" board 3 1/2" long (1) 3/16” bolts 2” long (12) 3/16” bolt 2 1/2" long (1) 3/16” Washer (26) 3/16” Nuts (13) 3/16” bolt 1 1/2" long (1) 1/4” nuts (2) 1/4” rod  15” long (1) 1/4" rod 15 1/4" long (1) 3/8” rod 19” long (1) Shaft 10” long lathed down to the size of the bearings and the heater fan wheel (1) Bearings Inside diameter 3/8” and outside diameter 1” (2) Bearing Brackets 1 5/16” Outside diameter, 1” Inside diameter and 1/2" wide (2) Copper mounting chain 12” long (1) 16” O-ring (1) 3” pulley (1) 1” pulley (1) Water Runway 4’ long then cut to what length you will need (As shown Below) (1) Turbine Brackets (As Shown Below) (2)          Fan Wheel off of a heater fan (1) Heater Fan motor (1) Submersible Sump Pump (1) 1 1/4" diameter pipe 35 1/2" long (1) Vapor Barrier 6”x4” (1) 1” hose 5’ long (1) 1” hose 18” long (1) 1 1/2" hose clamps (3) 1” ball valve (1) 1” hose barbs (2) 1 1/2" to 1” reducing nipple (1) 2.33 volt light bulb (1) 2.33 volt light bulb socket (1) Water Tap and Die set Tapping oil Soldering gun Soldering wire Goggles Welding gloves Teflon tape Utility Knife Variation of screwdrivers Extension cord Chop Saw Spray Adhesive Drill Press Ohms-meter Small clamps Variation of wrenches Calipers Bench Grinder Vise-grips Jig Saw Lock Tight Cordless drill Drill Press Variation of Drill Bits Lathe Square Soap Stone Tape measure Pencil Pen Skill Saw                                        Black Paint Centre punch Hammer Square Welder Buffer Grinder Protractor Paper